HiFi audiokaabel, maandus, müraisolaator, kõlar, CD-võimendi korpus, maandus, must auk, staatilise elektri eemaldamine.

[product name]: electronic black hole (electronic box) [Inner material]: Ultra-high density semiconductor wafer, isolation seag epoxy resin [Coat material]: mahogany [product size]:length 60MM diameter 28mm [product weight]: about 60g [Cable clip]: 20cm long single crystal sier wire+ copper alligator clip A new electronic black hole that eliminates static electricity and high-density electronic or boxes. 1. Ultra-small electronic grounding box, graphene + high energy density semiconductor material to achieve the effect beyond the traditional box. 2. Uncompromising use of materials, high-reduction laboratory-grade copper lead, WTB sier solder, without any connector transfer, the lowest dyeing. 3. Low-key and urious school sound style, without any dyeing, focus on improving the sound quality. 4. This product adopts semiconductor passive design. Because it does not receive electricity, it will only absorb free electrons in the system, purify the power supply, and filter noise. Therefore, it has no negative impact on the device itself, and it will only improve the sound quality. Principle oction: 1. It can reduce the static electricity generated by the accumulation of free electrons, so that the equipment casing maintains a stable potential and reduces interference with signals. The sound is more stable and the sound field is more clear. 2. It can reduce the static potential energy of electrons. Instructions: 1. Connect to the case, preferably on the screw. It can change the spatial separation well and the sound is simulated. It is best to use every device in the system. Note: 1. Different screws on the device have different sounds and you can try more. 2. Connect the negative terminal of the speaker terminal of the amplifier output to improve the sofess of the sound. 3. One device can use multiple electronic black holes, and the effects can be superimposed. 4. If the case has no conductive place, try to clamp it on the interface.